Link electronic Door phone Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Domofony Link electronic Door phone. Link electronic Door phone User's Manual Instrukcja obsługi

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj

Podsumowanie treści

Strona 1 - Link Slim Door Phone

Doorphone Link Slim Door Phone User Guide for Link Slim Door

Strona 2

10 4.2 Programming from a PC – ID Manager program To setup the unit from a PC you will require a special USB to

Strona 3 - 2 Installation

11 nn – telephone number up to 16 digits to be stored. Refer to the table for other choices. The number stored in parameter 2 is the number for th

Strona 4

12 5.3 Basic parameters Parameter Value Description Default Exam.1 Exam.2 41 v Dialling type 0 0 0 v – dial

Strona 5 - 2.1.5 Voice level

13 d – maximum time in minutes for which a call may last. This time can be extended during a call by dialling Prolong Call digit from telephone (

Strona 6

14 – p time is simultaneously the duration of interdigit gap at pulse dialling. 5.5 Presetting and De

Strona 7 - 2.3 Changing name cards

15 z=3 – all tones are active – (default) It is possible to generate an audible signal (only in mode m=1) to alert visitors that the door is unlo

Strona 8 - 3 SlimDoorPhone Services

16 50 p Pause duration (ms) 8 (800ms) 8 (800ms)8 (800ms) 6# s Number of fitted buttons on basic module 6* t D

Strona 9 - 4 Parameter programming

17 7 Table for easy programming Complete the values you want to program in the empty part of table on the next page. All programming commands a

Strona 10 - 5 Parameter description

18 8 Drilling master board

Strona 11 - 5.2 Relay

2 Contents 1 BASIC DESCRIPTION... 3

Strona 12 - 5.4 Time parameters

3 1. Basic description 1.1 Features ¾ Very slim module for surface mounting only. Supplied in 1, 2 or 4 button variants. ¾ Voice communication po

Strona 13

4 2.1.2 Uncover control elements 4. Push the aluminium speaker grille down (see figure – 4). 2.1.3 Wirin

Strona 14 - 5.7 System setting

5 2.1.4 Switches 7. The switch number 1 (see figure – 8) activates heating of the PCB. This is for increased resistance against humidity. To use

Strona 15 - 5.8 Overview of Parameters

6 2.2 Location of ID Doorphone components All mounting, control and setting elements are located under the spea

Strona 16 - 6 Technical parameters

7 2.3 Changing name cards Name card panel (0on page 3) has spaces to insert printed name cards. Insert name cards from top (see picture). Cards

Strona 17

8 3 SlimDoorPhone Services 3.1 Signalling Overview The unit signals acoustic conditions that may occur during op

Strona 18 - 8 Drilling master board

9 dialled to close the relay (parameter 35), releasing the lock. Hanging up the telephone will end the call, as will the busy tone from the PBX. 3.

Komentarze do niniejszej Instrukcji

Brak uwag